Start of telemetry-logging upon powering the heli and stopping the logging when unpowering the heli.
Result is one log-file per flight, easier to manage files.
Requirement
– Telemetry for flight-pack. (Didn’t work for me with RX-voltage)
In function:
Start, heli unpowered:
Powered, telemetry-logging started, not yet in flight
Landed after flight, hold-mode, timer stopped, still writing logs
Unpowered, sopped writing logs
How-to
This is a simple thing to do. We only need a telemetry-control to be active when there’s power in the heli. Easily done with monitoring voltage from flight-pack:
Simply put the activation value low-enough. Logging setup:
Set the telemetrty logging to use the newly created MX1 telemetry-control, also define the mode to “start/stop”
That’s it!
Thank you for the tip, it drove me nuts. Just switched to Jeti due to the amazing system it has but sooo many option!
I'll go now through all your Jeti post, this is already the second unvaluable tip.
Cheers,
Dorin
Does this work with the MUI telemetry sensor? Can't seem to get it working on DS24?
Yes it does, the example above is done with MUI. You can take screenshot's of your setup screen as above and send them through contact-page and I can have a look if needed.
I am also having a problem with MUI.
Timers/Sensors. –
Alarm
add Mac
set condition =>4500mAh
No activated switch
Attach a voice file
BUT – after flight and then battery change, the Tx ttun=rns on and show value from last flight
I cant see how to re-set this on battery change?
Add mAh not Mac – spell checker!