Jeti Fuel Sensor is Updated

Jeti Fuel Sensor (here) is updated to version 1.6.

What is changed?

Calibration screen have always shown the pulse-count from the flow-sensor. This was a bit confusing to users since after calibration to for example 25020 pulses and after saving it would show 0* where the 0 was the pulse-count, obviously zero after restart and the * to indicate that the sensor is calibrated.

New Calibration Screen

If sensor is not calibrated or calibration value is reset the Jetibox screen will show pulse-count. In this mode user can either set the calibration-value manually or pump one liter of fuel through flow-sensor. If the calibration is done (and saved…) the screen will show the calibration-value. Simple, after all.

Enjoy :)

Leave a Reply

Your email address will not be published. Required fields are marked *